Setup guide

Removing the Shipping Screws

To prevent damage during shipping, screws are attached to the TPU to secure its

lamp assembly. You must remove these screws before using the TPU.

To avoid damaging the TPU, make sure you don’t leave either

of the shipping screws in place when you use the unit.

1. Turn the TPU so the glass side

faces up.

2. Use a Phillips (cross head)

screwdriver to remove both

shipping screws from the holes

labeled

CLAMP

, as shown:

3. Install the screws in the storage

holes labeled

STOCK

between

the shipping holes.

Before transporting the scanner, turn it off, remove the TPU, and replace the

shipping screws in the outer holes labeled

CLAMP

. You must also lock the

transportation lock screw on the scanner before transporting it. (See your electronic

EPSON Expression 836XL User’s Guide.

)

If you can’t replace the shipping screws, the TPU’s lamp

assembly may not be in its home position. Reattach the TPU to

the scanner, close the unit, and turn on the scanner. The lamp

assembly returns to its home position. Then turn off the

scanner, remove the TPU, and insert the screws.

storage

holes