Setup guide

56
Setup Problems
If your system doesn’t recognize
the SCSI board (Windows
only). . .
■
Check the Plug and Play option
for your computer; it should be
active.
■
Make sure your SCSI board is
installed correctly. If it isn’t seated
firmly in the PCI slot, the
computer may not recognize it.
■
Run EZ-SCSI, a special SCSI
configuration utility for
Windows 95, 98, and NT. Insert
your EPSON Expression 836XL
Scanning Tools CD-ROM. Click
Start
,
then click
Run
. Type
D:\Adaptec\Ezscsi\Setup (where
D:
is your CD-ROM drive) and
click
OK
, then follow the
instructions on the screen. After
you restart your computer, your
system should recognize your
SCSI board.
If your system doesn’t recognize
the scanner. . .
■
Make sure your scanner is on.
If you opened your host
application before you turned on
the scanner, close your application
and reopen it. If that doesn’t
work, restart your system.
■
Check the Plug and Play option
for your computer (Windows
only); it should be active.
■
Make sure your SCSI board is
installed correctly.
■
If the SCSI board is found,
but not the scanner, check
the SCSI terminator and ID.
Make sure the SCSI ID doesn’t
conflict with another SCSI device.
■
Check the SCSI cable connection
or try another cable.