Service manual

EPSON Stylus Photo R200/R210 Revision A
ADJUSTMENT Adjustment Except Adjustment Program 84
5. Move "Carriage Unit" to the left edge of the printer, then set the Thickness Gauge
(1.15mm) on the left ribs (X3) of "Paper Guide, Front".
Figure 3-7. Setting Thickness Gauge
6. Implement PG Adjustment on the left according to the flowchart in the Figure 3-8.
Figure 3-8. PG Adjustment (Left Side)
7. Remove the Thickness Gauge and move "Carriage Unit" to the right edge. Then,
set the Thickness Gauge on the right ribs (X3) of "Paper Guide, Front".
Figure 3-9. Setting Thickness Gauge
8. Implement PG Adjustment on the right according to the flowchart in the Figure
3-10.
Figure 3-10. PG Adjustment (Right Side)
Thickness Gauge
Ribs
Yes
No
Note: Take down toward the printer front by 1 notch:
PG gets narrower.
Take up toward the printer back by 1 notch:
PG gets wider.
Take up: PG gets wider
Take down: PG gets narrower
Take down "Bushing, Parallel
Adjust, Left" toward the
printer front by 1 notch.
Go to Step 7.
Start
Take up "Bushing, Parallel
Adjust, Left" toward the
printer back by 1 notch.
Move "Carriage Unit" to
the right by using
"Timing Belt".
Does the Thickness
Gauge move?
Yes
No
Move "Carriage Unit" to
the right by using
"Timing Belt".
Does the Thickness
Gauge move?
Thickness Gauge
Ribs
Yes
No
Take up:
PG gets wider
Take down: PG
gets narrower
Start
Move "Carriage Unit" to
the left by using "Timing
Belt".
Does the Thickness
Gauge move?
Note: Take down toward the printer front by 1 notch:
PG gets narrower.
Take up toward the printer back by 1 notch:
PG gets wider.
Take down "Bushing, Parallel
Adjust, Right" toward the
printer front by 1 notch.
Go to Step 9.
Take up "Bushing, Parallel
Adjust, Right" toward the
printer back by 1 notch.
Move "Carriage Unit" to
the left by using "Timing
Belt".
Does the Thickness
Gauge move?
Yes
No