User manual

37
Enabling Wi-Fi Direct Mode
You can enable Wi-Fi Direct mode to allow direct communication between your product and computer or
other devices without a wireless router or access point.
1. Press the home button, if necessary.
2. Press the arrow buttons to select Wi-Fi Setup and press the OK button.
3. Press the right arrow button to select Wi-Fi Direct and press the OK button.
4. Press the OK button three more times.
You see this screen:
5. Press the OK button to complete setup.
You see the icon on the LCD screen and should be able to connect to your product directly
from your computer or device, and then print. If you are printing from a computer, make sure you
installed the network software as described on the Start Here sheet.
Note: Make a note of the SSID and password that appear. If you want to change the password, see
the link below.
If the icon is displayed on the LCD screen, Wi-Fi Direct mode is not enabled. Repeat these steps to
try again.
Changing the Wi-Fi Direct Mode Password
Parent topic: Wi-Fi Direct Mode Setup