User manual

Lancaster

short.bk Rev.C

A5 size SETUP.FM

2/5/99 Pass 3

Proof Sign-off:

Y.Yano _______

N.Nomoto _______

K.Pipa _______

If you are going to use the optional LocalTalk Interface Card

(C82312✽) or Type B Ethernet Interface Card (C82362✽/

C82363✽/C82364✽), you need to assign a name to your printer

using the EPSON Namer utility as described below. If you are

using a serial or USB interface, skip to “Selecting Your Printer in

the Chooser” on page 29.

Assigning a name to the printer

Follow these steps to assign a name to your printer with EPSON

Namer.

Note:

Only the network administrator should assign a name to the printer.

1. Double-click the

Epson Namer

icon.

If you have installed the

Epson Namer

utility on your

Macintosh, its icon is located in your hard disk folder. If it has

not been installed, insert the printer software CD-ROM into

your computer’s CD-ROM drive and open the utility from

there. (If you use the floppy disk version, insert it in a disk

drive and open the utility from there.)

2. Click the

SC900(AT)

icon in the Device Types window.

3. If there are multiple AppleTalk zones at your site, select the

zone where the printer is located.

4. Under New Name, enter a name for your printer. You should

assign a name that clearly distinguishes your printer from

others on the network.

5. Click

Rename

and then click

Done

to quit the EPSON

Namer.