Installation Manual

ManualsBrandsEpson ManualsComputersWorkForce Pro WF-4740 All-in-One Inkjet Printer

Table Of Contents

Start Here

Read these instructions before using your product.

The illustrations show the WF-4740, but the steps are the same

for all models, unless otherwise speciﬁed.

Note for Spanish speakers/Nota para hispanohablantes:

Para obtener instrucciones de conﬁguración en español, visite la página

de soporte de su producto en www.epson.com/support (EE.UU.) o

www.epson.ca/support (Canadá) y consulte la Guía de instalación

(requiere una conexión a Internet).

Unpack

Note: Do not open the ink cartridge packages until you are ready to

install the ink. Cartridges are vacuum packed to maintain reliability.

1 Remove all protective materials from the product.

2 Lift up the scanner unit until it locks and remove all

protective materials from inside the product.

3 Lower the scanner unit.

Turn on and configure

1 Connect the power cord to the back of the product and to

an electrical outlet.

Caution: Do not connect to your computer yet.

2 Raise the control panel and turn on the product.

3 Select your language, country, and time.

Note: You can change these settings later using the product’s

control panel. For more information, see the online User’s Guide.

Install ink cartridges

Caution: Keep the ink cartridges out the reach of children and do not

drink the ink.

1 Lift up the scanner unit until it locks.

Caution: Do not touch the ﬂat, white cable.

2 Gently shake the ink cartridges.

3 Unpack the ink cartridges.

WF-3720/WF-4720/WF-4730/WF-4740 Series

Summary of content (4 pages)

PAGE 1
WF-3720/WF-4720/WF-4730/WF-4740 Series Start Here 2 Turn on and configure 1 onnect the power cord to the back of the product and to C an electrical outlet. Caution: Do not connect to your computer yet. Read these instructions before using your product. The illustrations show the WF-4740, but the steps are the same for all models, unless otherwise specified.
PAGE 2
4 Remove only the yellow tape from each ink cartridge. WF-3720: 4 Load paper 1 ake sure the product is done charging the ink, and then M close the control panel, lift the output tray, and pull out the paper cassette. 2 lide the side edge guides all the way out and set the S front edge guide to the paper size you are using. 3 Insert paper with the glossy or printable side down. Caution: Do not remove any other labels or seals, or ink will leak. Do not touch the green chip on the cartridge.
PAGE 3
6 Pull out the output tray extension. 3 ollow the instructions on the computer screen to run the F setup program. Mac: Make sure you install Epson Software Updater to receive firmware and software updates for your product. 4 7 Select the paper settings on the product’s control panel. For more information on loading different paper types or envelopes, see the online User’s Guide. 5 Connect the fax line 1 onnect a phone cord to a telephone wall jack and to the C LINE port on your product.
PAGE 4
There are lines or incorrect colors in my printouts. Run a nozzle check to see if any of the print head nozzles are clogged. Then clean the print head, if necessary. See the online User’s Guide for more information. The printer’s screen is dark. Make sure your product is turned on, and press the screen or power button to wake it from sleep mode. Need paper and ink? nsure peak performance and brilliant results E with Genuine Epson Ink and specialty papers, engineered specifically for Epson printers.