User Manual
Table Of Contents
- Before Use
- Part Names and Functions
- Setup
- Removing the Protective Materials and Tape
- Installing the Printer
- Connecting the AC Adapter
- To install the AC Adapter (only for the TM-J7700)
- Connecting the Interface Cable
- Attaching the Power Switch Cover
- Changing the Roll Paper Width
- Turning On/Off
- Installing/Replacing the Roll Paper
- Inserting Slip Paper
- Installing/Replacing the Ink Cartridge
- Test Printing
- Maintenance
- Transporting
- Troubleshooting
- Specification
- Consumable Products
- Appendix
12
English
Connecting the AC Adapter
!WARNING:
Be sure to use the specified AC adapter [PS-180 (model: M159E)]. Connection to an improper power
source may lead to equipment damage, fire, or electric shock.
Connect the AC Adapter by following the procedure below.
For the TM-J7700, you can connect an AC adapter to the underside of the printer. Follow the instructions to
install it properly. (U
"To install the AC Adapter (only for the TM-J7700)" on page 13)
1. Confirm that the power switch is off.
2. Firmly insert the DC connector of the AC adapter into the DC-in ("24V") connector of the printer.
3. Firmly insert the AC cable connector into the AC port of the AC adapter.
4. Firmly insert the plug into a grounded wall outlet.
5. Set the AC adapter so that its label side is facing down.
DC-in (24V)
➀
➁
➂