User Manual
Table Of Contents
- Before Use
- Part Names and Functions
- Setup
- Removing the Protective Materials and Tape
- Installing the Printer
- Connecting the AC Adapter
- To install the AC Adapter (only for the TM-J7700)
- Connecting the Interface Cable
- Attaching the Power Switch Cover
- Changing the Roll Paper Width
- Turning On/Off
- Installing/Replacing the Roll Paper
- Inserting Slip Paper
- Installing/Replacing the Ink Cartridge
- Test Printing
- Maintenance
- Transporting
- Troubleshooting
- Specification
- Consumable Products
- Appendix
13
English
To install the AC Adapter (only for the TM-J7700)
Follow the procedure below to install the AC Adapter.
Q
Notes:
Perform the following when installing the AC adapter.
• Be sure to use a dedicated AC adapter [PS-180 (model: M159E)].
• Install the AC adapter so that its label can still be seen after it is attached.
• Use a straight plug for the AC inlet side of the power cable. If you do use an L-shaped plug, install the printer near
the power outlet and be sure that the plug can be easily disconnected.
• Be sure to thoroughly read and understand the information on the label of the AC adapter (rating, Warning/
Cautions) before installing it to the printer unit.
1. Turn the printer over.
2. Bundle the DC cable of the AC adapter as shown in the illustration.
The dimensions show are approximate and for use only as a rough guide.
3. Set the bundled part of the DC cable into the empty space inside the printer indicated by the circle.
Insert the DC cable next to the two posts on the bottom of the printer to securely store the adapter.
150 mm {6”}
300 mm {12”} 200 mm {8”}
Posts
➀
➁