User Manual
Table Of Contents
- Before Use
- Part Names and Functions
- Setup
- Removing the Protective Materials and Tape
- Installing the Printer
- Connecting the AC Adapter
- To install the AC Adapter (only for the TM-J7700)
- Connecting the Interface Cable
- Attaching the Power Switch Cover
- Changing the Roll Paper Width
- Turning On/Off
- Installing/Replacing the Roll Paper
- Inserting Slip Paper
- Installing/Replacing the Ink Cartridge
- Test Printing
- Maintenance
- Transporting
- Troubleshooting
- Specification
- Consumable Products
- Appendix
16
English
Connecting the Interface Cable
Connect the interface cable to be used to the connector on the rear side of the printer.
(U
"Input/Output Ports" on page 9)
Connect the cable to be used to either the USB type-B connector or Ethernet connector.
!CAUTION:
When using a USB cable, pass the cable through the wire saddle to prevent accidental disconnection.
Wire saddle
TM-J7200
Wire saddle
TM-J7700