User Manual
Table Of Contents
- Before Use
- Part Names and Functions
- Setup
- Removing the Protective Materials and Tape
- Installing the Printer
- Connecting the AC Adapter
- To install the AC Adapter (only for the TM-J7700)
- Connecting the Interface Cable
- Attaching the Power Switch Cover
- Changing the Roll Paper Width
- Turning On/Off
- Installing/Replacing the Roll Paper
- Inserting Slip Paper
- Installing/Replacing the Ink Cartridge
- Test Printing
- Maintenance
- Transporting
- Troubleshooting
- Specification
- Consumable Products
- Appendix
18
English
Changing the Roll Paper Width
You can move the roll paper guide installed in the printer to adjust for use with any of the following four
paper widths: 57.5/69.5/76/82.5 mm {2.26/2.74/2.99/3.25"}. The default setting is 76 mm {2.99"}.
Follow the procedure below to change the paper width.
!CAUTION:
❏
Do not change to wider paper width after using a narrower paper width. The autocutter blade may be
worn and may not be able to cut cleanly.
❏
When changing the paper width, be sure to change the setting for the paper width by using the utility
software for the TM-J7200/TM-J7700.
1. Make sure the printer is turned off.
2. Open the roll paper cover by pressing the cover open button.
3. Remove the screw holding the roll paper guide located on the left side of the roll paper holder.