User Manual
Table Of Contents
- Before Use
- Part Names and Functions
- Setup
- Removing the Protective Materials and Tape
- Installing the Printer
- Connecting the AC Adapter
- To install the AC Adapter (only for the TM-J7700)
- Connecting the Interface Cable
- Attaching the Power Switch Cover
- Changing the Roll Paper Width
- Turning On/Off
- Installing/Replacing the Roll Paper
- Inserting Slip Paper
- Installing/Replacing the Ink Cartridge
- Test Printing
- Maintenance
- Transporting
- Troubleshooting
- Specification
- Consumable Products
- Appendix
26
English
8. Close the front cover.
The (Ink) LED will now turn off.
When the ink cartridge is installed for the first time, the (Power) LED flashes and initial ink charging
starts.
Q
Notes:
The ink cartridge included in the product package is used for initial ink charging. The printer uses ink to
prepare for printing when the ink cartridge is installed for the first time.
It takes at least two minutes to charge ink. The ink charging time varies depending on the conditions.
!CAUTION:
Never open any cover on the printer or turn off the printer during ink charging (while the (Power) LED
is flashing). Doing so during ink charging will consume a large amount of ink, which may require
replacement of the ink cartridge before completion of charging.
When ink charging completes, the (Power) LED changes from flashing to on.
Perform a test print to check if printing is performed properly. (U
"Test Printing" on page 27)