Service manual

REV.-A
1.2 Specifications
1.2.1 Hardware Specifications
1.2.1.1 Printing Method
Printing method:
Impact dot matrix
Pin configuration: 9 wires
(diameter 0.29 mm)
wire
Dot matrix:
2+--- --
$
0.35mm (lf12”)
3 ‘ -------
9
9&
Figure 1-2. Pin Configuration
9 x 7 matrix (high-speed draft)
9 x 9 matrix (draft)
18x 23 matrix
(NLQ)
1.2.1.2 Paper Handling
Feeding method:
Fanfold:
Cut sheet:
Envelope:
Label:
Roll:
Line spacing:
Friction feed (front/top)
Push tractor feed
(frontfrear)
Pull tractor feed (front./rear/bottom)
Push-pull tractor feed (front/rear)
Tractor feed
Friction feed
Friction feed
Tractor feed
Friction feed
1/6”, 1/8”, or programmable (min.1/216”)
1-4
.=. !..,
{....;’