Service manual
REV.-A
3) Pull tractor feed
● Set the release lever to the PULL position.
● Load the paper from the front, rear, or bottom entrance.
(The front or bottom entrance is recommended for thick paper or
labels.)
● Release the friction feed mechanism.
● Remove the paper-tension unit and attach the pull tractor unit.
● Insert the paper from either front or bottom.
● Multi-part paper must be carbonless.
● Do not perform reverse feeds.
4) Push-pull tractor feed
● Set the release lever to the REAR PUSH/FRONT PUSH position.
● Load the paper from the front or rear entrance.
● Release the friction feed mechanism.
● Remove the paper-tension unit and attach the pull tractor unit.
c
Remove any slack in the paper between the platen and the pull tractor.
s
Precisely adjust the horizontal position of the pull tractor and push tractor.
● Multi-part paper must be carbonless.
● Do not perform reverse feeds greater than 1/6”.
● Do not perform reverse feeds after the paper end has been detected.
1.2.1.3 Paper Specifications
See Tables 1-2, 1-3, 1-4, 1-5, 1-6, and 1-7.
Recycled paper, envelopes, and labels require the following environmental conditions.
Normal environment
Temperature: 15-25 deg. C (59-68 deg. F)
Humidity: 30-60
?!.
RH
Table 1-2. Specifications for Cut Sheets (Plain Paper)
Width
top insertion
148-257 mm (5.8-10.1”)
80-column
148-420 mm (5.8-16.5”)
136-column
front insertion 182-257 mm (7.2-10.1”)
80-column
182-364 mm (7.2-14.3”)
136-column
Length
Up to
364
mm (14.3”)
Thickness
0.065-0.14 mm
(0.0025-0.0055”)
Weight
14-24 lb (45-78 Kg) (52.3-90
g/m2)
Quality
Plain paper
Recycled paper (in normal environment)
...
-
~.
●
“-
1-6