Service manual

REV.-A
3.2.5.3 Removing the MOTOR ASSEMBLY, CR
r
..,., ,
[STEP 11
[STEP 2]
[STEP 3]
[STEP 41
[STEp 51
[STEp 61
Remove the PAPER GUIDE ASSEMBLY, top cover, front cover, paper eject cover, and tractor unit. ‘
(See Section 3.2.1.)
Remove the PANEL UNIT. (See Section 3.2.2.)
Remove the HOUSING ASSEMBLY, UPPER. (See Section 3.2.4.)
Remove the face screw (M3X7) securing the MOTOR ASSEMBLY, CR. After releasing the tension
spring, disengage the TIMING BELT from the MOTOR ASSEMBLY, CR and hang it on the hook.
Disconnect the connector CN13 on the BOARD ASSEMBLY, C094 MAIN. Remove the MOTOR
ASSEMBLY, CR.
Remove the two CBN (M3X6) screws on the back of the MOTOR ASSEMBLY, CR. Remove the
MOTOR ASSEMBLY, CR.
F
MOTOR ASSEMBLY, CR
Face Screw (M3X7)
=?*
!
Spring .
L
-i
‘-%
PLATE, BELT TENSION
! .)
‘L J
A
CBN (M3X6) ~—.
\\
\\\-
Figure 3-10. Removing the MOTOR ASSEMBLY, CR
Assembly Note
Position the MOTOR ASSEMBLY, CR on the PLATE, BELT TENSION correctly as shown below.
MOTOR ASSEMBLY, CR
Figure 3-11. Positioning the MOTOR ASSEMBLY, CR
-- ..%
f :’
.., ,.,
3-12