Service manual

Disassembly and Assembly
EPL4600 /ActionLaser 1600 Service Manual
3.2 DISASSEMBLY AND ASSEMBLY
This section describes and illustrates the procedures for removing and disassembling the
components of the EPL-5600/ActionLaser 16W. Cleaning is described in Chapter 6. The assembly
procedures are not described, except for special notes where necessary, because assembly can be
accomplished by performing disassembly in reverse.
3.2.1 Removal of the Video Controller Section
The control section is comprised of the video controller board (the C125 MAIN board) and the
control panel board. “
3.2.1.1 Video Controller Board (C125 MAIN Board) Removal
Before you remove the video controller board, make sure that you remove any optional cards or
cartridges. Otherm”se, you may damage the cartridge or card connectors on the board as well
as the cartridge or card itself.
1.
Turn the printer so that its left side faces you.
2. Remove the 2 SCB screws (M3 x 14) securing the interface card cover; then pull off the cover.
3. Remove the 3 SCB(S)(P1) screws (M3 x 6) that secure the metal bracket on the left side of the
printer.
r
SCB (M3 X 14)
Figure 3-1. Re~:;:;g the Interface
~~
SCB(S)(P1)
(M3 X 6)
Figure 3-2. Removing the 3 Screws
4. Pull the tab on the bottom of the bracket to release the video controller board, as shown below.
5. Grasp the board with both hands and pull it out of its slot.
Figure 3-3. Pulling the Tab
Figure 3-4. Removing
the Video
Controller Board
3-4
Rev. A