Service manual

.,.,. -,.
d
...,. .,
(“’
.. :;.,.
...,
. . . . .
f.
EPL-5600 /ActionLasar 16U0 Sanka Manual
Dhassamb/y and Assambly
3.2.3.2 Power Supply Unit (PWB-E) Removal
1.
2.
3.
4.
5.
6.
7.
Open the top cover. Rerr&ve the imaging cartridge. Cover the imaging cartridge to protect it
from light or place it in a dark area.
Remove the control panel. (Re!%r to Section 3.2.13.) “
Remove the paper cover.
Remove the right cover. (Refer to Section 3.2.2.l.)
Disconnect connectors CN1, CN4, and CN2 on the power supply board (PWB-E) and CN8 on
engine controller board
(PWB-A).
Disconnect the connectors for the interlock switch.
Remove 2 CP(0) screws (M3 x 6), and remove the power supply unit.
PWB-A Board
Figure 3-11. Removing the Power Supply Unit
3.2.3.3 Interlock Switch Removal
1. ~en the toP cover. Remove the ima@g cartridge. Cover the imaging cartridge to protect it
from light or place it in a dark area.
2. Remove the control panel. (Refer to Section 3.2.13.)
3. Remove the paper cover.
4. Remove the right cover. (Refer to Section 3.2.2.1.)
5. Remove the power supply unit. (Refer to Section 3.2.3.2.)
6. Remove
2 CC screws (M3 x 16) for the interlock switch, and remove the interlock switch.
CC (M3 X 16)
fi
o~
x
II 1
m
Figure 3-12. Removing the Interlock Switch
Rev. A
3-9