Service manual

Adjustment

EPL-5600/ActionLaser

1600 Service

Manual

10.

While holding the control panel, adjust the image synchronizing adjustment volume

(VRIA)

on the engine controller board

(PWB-A)

so that the gap for the print position of the horizontal

line (vertical print position) becomes 19.1 mm

(0.75 inch)

for

EPL-5600

or 14.3 mm (0.56 inch)

for ActionLaser 1600.

●

Turn VRIA clockwise to decrease the gap for the print position of the horizontal line.

●

Turn VRIA counterclockwise to increase the gap.

Turn on the printer.

Print a STATUS SHEET in SelecType to again check the print position.

Repeat steps 4 to 8 until the print position is 19.1 mm (0.75 inch) or 14.3 mm (0.56 inch).

Reattach the control panel, securing it with the one screw, close the paper cover, and close the

upper unit.

ure 4-3. Holding the Control

anel

and Adjusting

VRIA

Figure 4-4. Closing the Paper Cover

and the Upper

Unit

4-2

Rev.