Service manual

3.2.18 Separator Removal
1. Remove the outer covers. (Refer to Section 3.2.1.)
2. Remove the Fusing Unit. (Refer to Section 3.2.2 .)
3. Remove the Lower Fusing Roller.
4. Remove the springs that secure the separators to the hooks.
5. Slide the separating rolls, and remove them from the separators.
6. Remove the stoppers.
7. Slide and raise the separators to a right angle, and pull them upward to remove.
Assembly Note
Note the direction in which the stoppers are placed. The 3 stoppers on the right face in the
opposite direction to the 3 on the left.
Separator
Upper Fusing Roller
Hook
Spring
Separator
Separating Roll
Stopper
Shorter
Longer
Upper Fusing Roller
Figure 3-33. Separator Removal
Disassembly and Assembly EPL-N2000 Service Manual
3-32 Rev. A