Service manual

(12) SelecType/Alt
Selects One Touch Mode 1 or 2. Press this button repeatedly to scroll modes in the order:
SelecType Mode, One Touch Mode 1, One Touch Mode 2, and Normal Mode.
(13) Continue/Reset
If you press this button while the Continue LED is flashing, it clears the error. Pressing this
button while the On Line LED is OFF puts the printer back in Ready status. Pressing this
button while the On Line LED is OFF and the LCD displays a warning clears the warning. To
reset the printer, press this button and Alt button simultaneously, and LCD displays RESET. If
you hold down the buttons an additional 5 seconds, the LCD displays RESET ALL, and a warm
boot starts.
(14) Form Feed
The printer prints received data stored in its buffer if this button is pressed while On Line LED
is OFF and Data LED is ON. Dulex print is canceled and data is printed in the the single print
mode.
(15) On Line
If this button is pressed when On Line LED is ON:
Single-sided print: The printer goes off line immediately, and the page in process is ejected.
Duplex print: The printer goes off line after printing both sides of one sheet, or two
sheets, maximum.
The printer goes on line if this button is pressed when it’s off line.
1.4.2 Panel Settings
This printer has two panel setting modes: One Touch mode*
1
and the SelecType mode. One Touch
mode is more limited but easier to use. This mode has direct access to specified items in the menu
tree*
2
, while the SelecType mode has to follow the fully branched out menu tree to reach a
parameter. Therefore, descriptions for One Touch mode have been eliminated in this section. Once
new settings are registered on EEPROM, they are not changed until the printer is turned off. See
Table 1-20 for SelecType options.
*1: Changes made in One Touch mode only affect environments available in the currently selected
interface. See the user’s guide for details.
EPL-N2000 Service Manual Product Description
Rev. A 1-29