Service manual

1.4.4 Display of Messages
This section describes messages on LCD. They are divided into 4 categories; status messages, error
messages, warning messages, and service call error messages.
1.4.4.1 Status Messages
The LCD normally indicates the printer’s status and the software mode.
Table 1-20. Status Messages
Message Description and Corrective Measure
Reset All Warm boot is in process. Printer replaces this message with "Reset" while
performing reset after warm boot is completed .
Reset Reset is in process.
Reset to Save Printer status: SelecType is changed while another job is printing.
LED status: On-Line LED goes OFF.
Measures:
Press either Continue or On-Line to recover. Note that the setting made
in SelecType mode is not valid until current the job is complete.
To make a new setting take immediate effect, perform a reset or warm boot.
However, this clears all print data.
Warming Up The printer is warming up.
Standby The printer is in energy saver status.
Ready The printer is ready to receive new data.
Writing Card The printer is storing data to the PCMCIA card. Be sure to avoid turning off the
printer off or removing the card during this operation. The printer
automatically starts a warm boot when the process is completed.
Writing SIMM The printer is storing data to the Flash simm. Be sure to avoid turning off the
printer off or removing the card during this operation. The printer
automatically starts a warm boot when the process is completed.
EPL-N2000 Printer name is indicated in place of "Ready" when "Printer Name" is set to ON
in SelecType mode.
EPL-N2000 Service Manual Product Description
Rev. A 1-37