Service manual

Table 1-21. Error Messages (Continued)
Error Messages and Descriptions
Print Overrun
Status
The time required to develop an image exceeds the print speed because the
current data is too complicated.
LED
On Line
OFF: Size Ignore = OFF
ON Size Ignore = ON
Continue
Flashing
Form Feed
Keeps the same status as before.
Measure
This error can be cleared using any of the following methods:
[SelecType: Auto Cont = OFF in the Config menu]
1. Press the Continue button. If there is memory available, the printer
resumes printing of the page containing the error, using the memory left.
This is only attempted once, and if it results in the same error, the printer
omits the page containing the error and proceeds to the following page.
When the error occurs on the reverse side of a duplex page, both sides
are reprinted.
2. Perform reset or warm boot.
[SelecType: Auto Cont = ON in the Config menu]
3. The error is cleared automatically after a specific amount of time. If
there is still memory left, the printer resumes printing on the page
containing the error, using the memory left. This is only attempted once
and if the same error occurs, the printer omits the page with the error and
proceeds to the following page. When the error occurs on the reverse
side of a duplex page, both sides are reprinted.
4. Set Page Protect = ON in the printer driver.
5. Set Device Resolution = 300 dpi in the printer driver.
6. Add more memory.
Mem Overflow
Status
Memory has run out during a process, and the printer stops the current task.
LED
On Line
OFF: Auto Cont = OFF in the Config menu
ON: Auto Cont = ON in the Config menu
Continue
Flashing
Form Feed
Keeps the same status as before.
Measure See Page 1-43
Product Description EPL-N2000 Service Manual
1-42 Rev. A