User`s guide

Running the self test

The self test can be run in either draft or near letter quality

(NLQ) mode.

While holding down the

LF/FF

button (for draft mode) or

TEAR OFF

button (for NLQ mode), turn on the printer.

After printing starts, release the button.

The printer prints a series of characters. Here is part of a

typical self test printout in high-speed draft.

Note:

When NLQ quality is selected using DIP switch l-3, the serf test

runs in NLQ mode even if you press

the LF/FF

button.

The self test continues until the paper runs out or until you

press the

PA USE

button. If the test results are satisfactory

and you wish to stop the test, press the

PAUSE

button. (To

resume the test, press the

PAUSE

button again.)

To end the self test, press the

PA USE

button to stop printing

and then hold down the

LF/FF

button to advance the paper.

1-18

Set Up

and