Service manual

EPSON Stylus C82 Revision A
DISASSEMBLY AND ASSEMBLY Disassembly 26
4.2 Disassembly
The flowchart below shows step-by-step disassembly procedures. When disassembling each unit, refer to the page number shown in the figure.
Figure 4-1. Disassembling Flowchart
Upper Housing
Removal
4.2.1.1 P.27
Printhead Removal
4.2.1.3 P.28
Ink System Unit
Removal
4.2.3.7 P.39
Lower Housing/
Printer Mechanism
Removal
4.2.1.4 P.29
Paper Eject Frame
Unit Removal
4.2.3.10 P.40
EJ Roller Unit
Removal
4.2.3.11 P.41
Panel Housing/
C486 PNL Board
Removal
4.2.1.2 P.27
ASF Unit Removal
4.2.3.1 P.32
PE Sensor/
PE Sensor Holder/
PE Lever Removal
4.2.3.3 P.35
C486 Main Board
Removal
4.2.2.1 P.30
C486 PSB/PSE
Board Removal
4.2.2.2 P.32
CR Motor
Removal
4.2.3.8 P.39
PF Motor
Removal
4.2.3.9 P.40
ASF Unit Removal
4.2.3.1 P.32
CR Guide Shaft/
Carriage Unit
Removal
4.2.3.6 P.37
PF Roller Unit
Removal
4.2.3.15 P.42
* Use the flowchart to determine the shortest
procedure for the unit to be replaced, then
disassemble the printer by following that
procedure.
* The step for the unit or discrete part within the
broken line is not the shortest removal step but is
the step necessary for removing the next unit or
discrete part.
C486 Main Board
Removal
4.2.2.1 P.30
C486 PSB/PSE
Board Removal
4.2.2.2 P.32
PF Encoder &
PF Encoder Base
Removal
4.2.3.4 P.36
ASF Unit
Disassembly
4.2.3.2 P.33
Front Paper Guide
Removal
4.2.3.12 P.41
Linear Scale
Removal
4.2.3.5 P.37
PE Sensor/
PE Sensor Holder/
PE Lever Removal
4.2.3.3 P.35
Upper Paper Guide
Removal
4.2.3.13 P.42
Rear Paper Guide
Removal
4.2.3.14 P.42
PF Encoder &
PF Encoder Base
Removal
4.2.3.4 P.36