Service manual

EPSON Stylus C82 Revision A
DISASSEMBLY AND ASSEMBLY Disassembly 30
3. As shown below, remove AC Cable Cover and Ink Tube from Lower Housing and
C486 Main Board.
AC Cable Cover : Release while pushing 2 hooks in direction of arrow
A, then remove cover by pushing out in direction of
arrow B.
Ink tube : While pressing inward both edges of retainer, remove
Ink Tube in direction of arrow C.
Figure 4-13. Lower Housing/Printer Mechanism Removal 2
4. As shown above (lower left photo), while releasing hook in direction of arrow D,
lift Printer Mechanism and remove from Lower Housing.
4.2.2 Board Removal
4.2.2.1 C486 Main Board Removal
1. Remove Printer Mechanism. (See Section 4.2.1.4)
2. Remove all cables from C486 Main Board and peel off acetate tape in 2 places.
Figure 4-14. Main Board Removal 1
FFC
Disconnect
<Left Rear Side>
<Center Rear Side (Inner Side)>
AC Cable Cover
<Right Front Side>
C
Ink tube
Hook
Hook
A
A
B
Retainer
D
Hook
W A R N I N G
Make sure the tip of the waste ink tube is located at correct
position when reassembling the waste ink tube. Otherwise it will
cause ink leakage.
A D J U S T M E N T
R E Q U I R E D
When replacing the Printer Mechanism, the adjustments are
necessary. Refer to "Chapter 5 Adjustment" for the adjustment
procedures.
Cables
Acetate Tapes
C486 Main Board
<Left Rear Side>