Service manual

EPSON Stylus C82 Revision A
DISASSEMBLY AND ASSEMBLY Disassembly 38
6. Remove CR Guide Shaft from Printer Mechanism in direction of arrow C while
taking care not to damage slots in Printer Mechanism.
7. Allow Carriage Unit to rotate in direction of arrow D and remove Carriage Unit
from Printer Mechanism.
Figure 4-36. CR Guide Shaft/Carriage Unit Removal 2
8. Disconnect FFC from connector on Relay Board of Carriage Unit, then remove
Carriage Unit.
Figure 4-37. CR Guide Shaft/Carriage Unit Removal 3
Carriage Unit
<Right Side><Left Side>
Spacer
PG lever
Bush
Torsion spring
67.78
Leaf
spring
1
7
Bush
Spacer
C.B.S (P4) 3x6
(6±1kgf.cm)
CR Guide Shaft
9
2
2'
5
4
3
Removal
Direction
6
8
Hooks
10
C
D
C.B.S (P4) 3x6
(6±1kgf.cm)
Slot
C A U T I O N
Be careful when installing the Bushings at each side of the Printer
Mechanism because the Left Bushing and Right Bushing have
different shapes. (See Figure 4-36)
 Leaf Spring Installation
Figure 4-38. Leaf Spring Installation
A D J U S T M E N T
R E Q U I R E D
When removing or replacing the CR Guide Shaft/Carriage Unit,
the adjustments are necessary. Refer to "Chapter 5 Adjustment"
for the adjustment procedure.
Relay Board
FFC
Connector
PG lever
Leaf spring
Bush