Service manual

EPSON Stylus C82 Revision A

DISASSEMBLY AND ASSEMBLY Disassembly 39

4.2.3.7 Ink System Unit Removal

1. Remove Printer Mechanism. (See Section 4.2.1.4)

2. Remove 2 screws ((1)C.B.S 3x8, (2) C.B.S 3x6) holding the Ink System Frame,

then remove the Ink System Frame from the Printer Mechanism.

3. Remove 2 screws ((3)C.B.S 3x8, (4) C.B.S 3x6) holding the Ink System Frame

from the Printer Mechanism.

Figure 4-39. Ink System Unit Removal

4. When ASF Unit is installed, release union location of Pump Frame and ASF Unit.

(See Section 4.2.3.1 Step 4)

5. Remove Ink System Unit from the Printer Mechanism.

6. Follow the order shown above to remove the 0 Digit Flashing Box from the Printer

Mechanism.

4.2.3.8 CR Motor Removal

1. Remove Printer Mechanism. (See Section 4.2.1.4)

2. Disconnect CN14 connector from C486 Main Board.

3. Remove 1 screw (C.C 3x4) holding CR Motor, then remove CR Motor.

Figure 4-41. CR Motor Removal

2. C.B.S 3x6 (8±1kgf.cm)

Ink System Frame

Ink System Unit

0 Digit Flashing Box

Push & lift

4. C.B.S 3x6 (8±1kgf.cm)

3. C.B.S 3x8 (8±1kgf.cm)

1. C.B.S 3x8 (8±1kgf.cm)

C A U T I O N

Use a pair of tweezers to replace the Cleaner Blade. While doing

this, do not touch the Printhead with the tweezers. In addition, do

not touch the Printhead with bare hands.

Figure 4-40. Cleaner Blade Handling

Cleaner Blade

Contact Location

CR Motor

C.C 3x4 (3±1kgf.cm)

Label side