Service manual

EPSON Stylus C82 Revision A
DISASSEMBLY AND ASSEMBLY Disassembly 42
4.2.3.13 Upper Paper Guide Removal
1. Remove Front Paper Guide and PE Sensor Holder. (See Section 4.2.3.12 and
4.2.3.3)
2. Release 2 hooks holding each Extension Spring 4.07, then remove Extension
Spring 4.07 (4 springs).
3. Follow order shown below to remove Upper Paper Guide from Printer
Mechanism.
Figure 4-47. Upper Paper Guide Removal
4.2.3.14 Rear Paper Guide Removal
1. Remove Upper Paper Guide and C486 PSB/PSE Board. (See Section 4.2.3.13 and
4.2.2.2)
2. Release Rear Paper Guide from right side hook, then shift Rear Paper Guide in
direction of arrow A.
3. Release 2 hooks fastening Rear Paper Guide to PF Roller Unit, then remove Rear
Paper Guide by pushing it in direction of arrow B.
Figure 4-48. Rear Paper Guide Removal
4.2.3.15 PF Roller Unit Removal
1. Remove Rear Paper Guide. (See Section 4.2.3.14)
2. Use tweezers to remove leg of Compression Spring 4.89 from Printer Mechanism.
3. Use tweezers to release left and right Bushing 8 fastening PF Roller Unit to Printer
Mechanism, then allow the PF Roller Unit to rotate in directions shown by arrows
A and B.
4. Follow the order shown below to remove PF Roller Unit from Printer Mechanism.
Figure 4-49. PF Roller Unit Removal
Extension Spring 4.07
Upper Paper Guide
1
2
<Rear Side>
Hooks Hooks
When installing Rear Paper Guide, if hooks are not completely
fastened, the ASF Unit cannot be properly set.
A
Hook
HookHook PF Roller Unit
B
Rear Paper Guide
1
2
3
PF Roller Unit
Compression Spring 4.89
A
B
4
Bush 8
Bush 8