Service manual

EPSON Stylus C82 Revision A
MAINTENANCE Overview 48
6.1.3 Lubrication
The types lubricants used in the Stylus C82 are specified by SEIKO EPSON. Lubricate
the printer if necessary under the following conditions:

Grease has been wiped off during cleaning.

Printer has been disassembled/assembled.

Specific part(s) in the printer has been replaced.
C A U T I O N
 Never use grease other than those specified in this manual. Use of
different types of grease may damage the component or give bad
influence on the printer function.
 Never apply larger amount of grease than specified in this
manual.
Table 6-1. Grease Applied to the Stylus C82
Type Name EPSON Code Supplier
Grease
G-26 1080614
EPSON
G-46 1039172
G-63 1218320
C A U T I O N
 No adhesion is used in the Stylus C82.
 When applying G-46 without changing any parts, use the Flux
Dispenser (1049533) to apply one coat to specified areas. Because
it is necessary to apply G-46 when replacing old parts with new
parts, soak the parts in G-46 as shown in the photograph on page
50.
Table 6-2. Lubrication Points
Fig No. Lubrication Point/Type Remarks
6-1
<Lubrication Point>
• Driven Roller x 8
<Lubrication Type>
•G-46
<Lubrication Amount>
• Soak in basin containing G-46 and remove
immediately.
• Joint use of Flux Dispenser is
recommended.
6-2
<Lubrication Point> (No.1)
• Paper Back Lever shaft socket (2 places)
<Lubrication Type>
•G-26
<Lubrication Amount>
• Shaft socket entire length
• Use a brush to apply it.
<Lubrication Point> (No.2)
• Paper Back Lever left end
<Lubrication Type>
•G-46
<Lubrication Amount>
• Soak in basin containing G-46 and remove
immediately.
• Joint use of Flux Dispenser is
recommended.
6-3
<Lubrication Point>
• Paper Back Support Lever
<Lubrication Type>
•G-46
<Lubrication Amount>
• Soak in basin containing G-46 and remove
immediately.
• Joint use of Flux Dispenser is
recommended.