Service manual

EPSON Stylus C82 Revision A
MAINTENANCE Overview 49
6-4
<Lubrication Point>
• LD Roller Shaft left/right ends
<Lubrication Type>
•G-46
<Lubrication Amount>
• Soak in basin containing G-46 and remove
immediately.
• Joint use of Flux Dispenser is
recommended.
6-5
<Lubrication Point>
• Combination Gear Ratchet 65.6 &
Spur Gear 48
<Lubrication Type>
•G-46
<Lubrication Amount>
• Soak in basin containing G-46 and remove
immediately.
• Joint use of Flux Dispenser is
recommended.
6-6
<Lubrication Point>
• The right end of PF Roller unit on metal
surface a circle.
<Lubrication Type>
•G-26
<Lubrication Amount>
•
φ
1 x 3mm
• Do not attach the grease to the
paper path.
• Be carefully not lubricate on
coated surface.
• Do not touch coated surface of
PF Roller.
• Use a brush to apply it.
6-7
<Lubrication Point>
• Carriage Unit Shaft Socket
<Lubrication Type>
•G-63
<Lubrication Amount>
• Shaft Socket Inner Side
• Use a brush to apply it.
Table 6-2. Lubrication Points
Fig No. Lubrication Point/Type Remarks
6-8
<Lubrication Point>
• Pulley Driven Holder
<Lubrication Type>
•G-26
<Lubrication Amount>
• φ1 x 2mm x 4points
• Use a brush to apply it.
6-9
<Lubrication Point>
• Main Frame Upper Part back side
(Between Change Lever and Main Board
Unit)
<Lubrication Type>
•G-26
<Lubrication Amount>
•
φ
1 x entire length
• Use a brush to apply it.
6-10
<Lubrication Point>
• Joint between ASF Trigger Lever and ASF
Frame
<Lubrication Type>
•G-26
<Lubrication Amount>
• Protrusion surface area
• Use a injector to apply it.
6-11
<Lubrication Point>
• ASF Trigger Lever Right End
<Lubrication Type>
•G-26
<Lubrication Amount>
• Corner surface area
• Use a brush to apply it.
Table 6-2. Lubrication Points
Fig No. Lubrication Point/Type Remarks