User`s manual

47
47
9.18 Clear current line, and cancel string mode
The current line is cleared, and the string mode is cancelled.
9.19 Brightness adjustment
Adjust the brightness of the vacuum fluorescent display.
When n=3,brightness=70%
When n=4,brightness=100%
9.20 Set cursor ON or OFF
When n=0, cursor is OFF
When n=1, cursor is ON
9.21 Set user-defined characters
The n defines the beginning character code, and m defines the ending
character code. When only one character is defined, use n=m. The ‘a’
denotes the number of dots in the horizontal direction. When a<5, the dot
pattern for ‘ a’ on the right side of the user-defined characters are padded
with spaces p1 .. pa, the dot data is to defined the characters. This
indicates the dot pattern for /a/ in the horizontal direction from the left side.
9.22 Reset user defined character set
When n=1, user-defined characters are selected. When the user-defined
characters are not defined by the ESC & command, the internal character
set will be displayed.
When n=0, user-defined characters are cancelled and the international
character set is selected.
9.23 Cancel user defined characters
User-defined characters are cancelled.
This command cancels the defined characters specified by n. If specified
code is transmitted after the pattern is cancelled, the international character
will be displayed.
9.24 Store the user defined character into EEPROM
If EEPROM is not supported, this command is ignored.