System information

__________________________________________________
Blastware Compliance Module
Blastware Operator Manual 4–87
Note: For setting up the UDP/IP or TCP/IP communications protocols it is
suggested that you contact your System Administrator to handle Windows®
Firewall adjustments and router configurations.
8. Refer to the Reports Section. Establish where your data output files will be located once
they are downloaded, and their file format. Additionally, determine the download
location of Event and FFT Report Metafiles and formats, along with the measurement
system to be applied.
9. Proceed to the Start Auto Call Home Section.
10. Use the various testing features to determine that the modem and software configurations
are working in the office prior to locating the system as a field installation.
4.4.3 Description of Commands
a. Setup Unit
Access this dialog by selecting Remote Access Menu > Auto Call Home > Setup Unit. The
Setup Unit command opens the Call Home Setup dialog box. The settings made in the Call Home
Setup dialog box are stored directly on the unit. If you are using Auto Call Home with more than
one monitor, you must set up each monitor individually.
(1) USR Modem or Radio Modem
i Dial-up modem option
If you’re connecting your instrument to a cellular modem or a telephone line modem, then
place a check mark on the Enable Auto Call Home and click on the USR Modem button.
ii IP modem option
If you’re using a Raven modem or any other type of Internet modem or Radio modem, then
place a check mark on the Enable Auto Call Home and then press the Radio Modem button.