System information

Blastware Compliance Module
___________________________________________________
4–88 Blastware Operator Manual
This will place the Radio Ring command in the dial string section and automatically transmit
any data once it has been recorded. From here you will need to program the modem to
redirect the information to their router or directly to your computer.
Depending on the situation, you need to select if you want the unit to call home after each
event, at a specific time or both. Place the check mark(s) at the proper place(s).
Press the Send button to program the unit.
iii When to Call Home
These settings determine when the monitor calls in to your PC to download data. If your unit
is set to Histogram or Histogram Combo Recording Mode, you must schedule the unit to call
home.
iv After Event Recorded
To have the monitor download data after every Event, click on this checkbox to display a
checkmark. The monitor will call in after the wait time you specify, as set below.
v Wait ___ Minutes
Enter the length of time in minutes the monitor waits before calling in to your PC to download
data. Click on the text box and enter the time. If you want the monitor to call in immediately
after the Event, enter 0.
vi Monitor while calling home
Select this setting to ensure that the unit continues to record Events during downloading so
that no Events are missed. If an Event is triggered during a download, the unit will stop the
download, record the Event, and then restart downloading Events three minutes later to your
PC. This function works only with downloads that occur right after the Event, or after the pre-
set wait time. While in this mode, you are not able to set the time or delete Events.
Downloads scheduled at a specific time (see the next item) cannot be interrupted to capture an
Event.
vii At Specified Times
You can have the monitor call in at the same time every day, up to four times a day, to
download data. This setting is preferable for long-term monitoring as it ensures that the