System information

__________________________________________________
Blastware Compliance Module
Blastware Operator Manual 4–129
j. PVS (Peak Vector Sum)
This selection provides the Peak Vector Sum of ground, amplitude and frequency.
k. VDV (Vibration Dose Value)
This selection provides the Vibration Dose Value (VDV) daytime (vertical channel) or nighttime
(horizontal channels) VDV and RMS monitoring calculation results.
NOTE: For Series IV units only
l. PPV Cell Phone Page
Cell phone users can automatically receive the subject of the Event (e.g. BE6412 Nov 24 /00
2:55:55 PM), and the Transverse (Tran), Vertical (Vert) and Longitudinal (Long) Peak
information for each channel. The Microphone channels peak sound pressure is also included.
m. Accel Cell Phone Page
Cell phone users can automatically receive the subject of the Event (e.g. BE6412 Nov 24 /00
2:55:55 PM), and the Peak Acceleration of each channel. The Transverse (Tran), Vertical (Vert)
and Longitudinal (Long) Peak information for each channel, and the Microphone channels peak
sound pressure is also included.
n. VDV Cell Phone Page (Vibration Dose Value)
This selection provides the Vibration Dose Value (VDV) daytime (vertical channel) or nighttime
(horizontal channels) VDV and RMS monitoring calculation results.
NOTE: For Series IV units only
o. PVS Cell Phone Page
Cell phone users can automatically receive the subject of the Event (e.g. BE6412 Nov 24 /00
2:55:55 PM), and the Peak Vector Sum (PVS) of each channel. The Transverse (Tran), Vertical
(Vert) and Longitudinal (Long) Peak information for each channel, and the Microphone channels
peak sound pressure is also included.
p. Attach Event
Attach the entire Event to an email.
q. Attach Reports
Attach the Reports to the email. Select which Reports you would like to attach to an email by
selecting each box, Event, Meta, PDF, ASCII, or XML.
r. Delay (minutes)
Select this setting if you wish to have e-mail sent from the unit a specified period after each Event.
Enter a delay time in minutes.
s. Time
Use this setting to specify a specific time for the unit to send e-mail. Make sure that Blastware,
your and Internet connection is open, at the time specified.
t. Cancel
Returns you to the Blastware Mail main window, without retaining any of the changes that you
have made.
u. Delete All
Clears all addresses and settings.
4.5.3 Blastware Mail Example Setup
Below is an example of how to setup your computer to download Events from a remote monitor
and distribute them as e-mail. There are three steps to complete.