System information

Blastware Advanced Module
____________________________________________________
6–10 Blastware Operator Manual
Series IV Advanced Setup Dialog:
a. Recording Setup
(1) Channels
Configure the monitor channels using the following settings. These items can only be changed
using the Blastware software (Advanced Module).
i Select
Choose the channels to be used during advanced operations. Click on the checkbox to display a
checkmark to enable the channel. Channels must be enabled or disabled according to the following
restrictions; Channel 1 only, Channels 1 and 2, Channels 1 through 4, or Channels 1 through 8
(eight channel monitor required), Channels 1 through 6 (six channel monitor required).
ii Name (5 char max)
Enter a name to refer to the channel name. The name can be a maximum of five characters long.
iii Units (6 char max)
Enter a name to refer to the measurement units for each channel. The following table summarizes
Instantel sensor units. Refer to the manufacturers specifications for non Instantel sensors.