System information

Blastware Advanced Module
____________________________________________________
6–46 Blastware Operator Manual
Blastware displays a generic compliance graph. To create a new compliance graph, change the
generic graph accordingly then save it. Instantel does not recommend changing the compliance
graphs included with the Blastware program. If you change a graph inadvertently, you can replace
the graph with the original by installing Blastware again. After editing a compliance graph,
transfer it to the monitor and check its printout.
a. File Menu
The file menu contains the following commands.
(1) Load
This command loads an existing compliance graph into the compliance graph editor. You could
load an existing graph and change some aspects without having to create the entire graph.
(2) Save
After changing a compliance graph, choose this command to save the new graph. Remember to
enter a new name for the graph to avoid overwriting the graph supplied with Blastware.
(3) Exit
This command closes the dialog box and returns to the Blastware main menu. You may be
prompted to save the existing file. Enter a new name and click on OK. If you do not want to save
the changes, click on Cancel.
b. Edit Menu
The following commands appear in the Edit Menu.
(1) Lines
Use this command to draw lines on the graph. For example, the USBM R18507 and OSMRE
compliance graph displays OSMRE, USBM drywall or plaster, and USBM plaster lines.
To draw lines on the graph, open the Edit Menu and choose the Lines command. The
Compliance Graph Lines dialog box appears.