System information

Blastware Advanced Module
____________________________________________________
6–64 Blastware Operator Manual
4. The Signature Hole Analysis dialog appears:
This dialog box contains all the information to allow you to simulate your different delay patterns.
Determine the timing to be used under the Timeline Generation section. The number of
simulation files that will be generated will be equal to (number of Deck delays) X (number of Hole
delays) X (number of Row delays). To reduce the number of simulations and quickly eliminate
undesirable delays you can increases the increment number. The settings under the Sorting
Options section will establish the sort criteria, displaying only relevant entries and arranging the
priority of the listing based on your input. The Frequency Ratio section of the dialog indicates
the concentration of the Upper and Lower ranges in Hz. To remove any unwanted frequencies in
your signature hole waveform you can apply the band pass filter.
NOTE: removing any frequency from the signature hole waveform will also remove them from
the simulation results. It is always a good idea to look at the results before filtering to fully
understand the potential impact of filtering. Setting up a Project Directory allows you to keep all
your projects organized for future reference.
d. Signature Hole Analysis Dialog Overview
(1) Timeline Generation (assumes a corner blast)
This section of the Signature Hole Analysis dialog is for entering the values for the Number of
Decks per Hole, Holes per Row, and Rows.