System information

_____________________________________________________________
Modem Operation
Blastware Operator Manual 7–9
iv Close
This closes the dialog box.
(2) Modem File Section
This section displays the location and filename of the modem script file currently being changed.
i Type
Enter the modems name. Be specific if creating a script file for a new type of modem.
ii Note:
Use this box to add a further description about the modem.
(3) Debugging for
Each of the following commands corresponds to a different section within a modem script file.
i Dial
This command enters a telephone number and baud rate for the debugging mode. The
debugging mode requires a second modem to connect to and test the script file during its
development. Click on the Dial command to display the following dialog box.
Enter the telephone number for the second modem. Enter a baud rate to use when
communicating with this modem.
Note: Ensure both your PC and Remote modems were properly initialized and connected.
ii Hang Up
The Hang Up section contains the commands to hang up a modem and end a modem session.
iii Initialize PC Modem
The Initialize PC Modem section initializes a modem to act as the modem connected to your
PC.
iv Initialize Remote Modem
The Initialize Remote Modem section initializes a modem to act as the remote modem
connected to a remote monitor in the field.
(4) Hangup, Initialize PC and Initialize Remote Sections
A script file contains a section for each of these commands. To edit these sections, click on the
appropriate button. A dialog box appears for the section. The commands, within these each dialog
box perform the same function.