System information

Blastware Compliance Module
___________________________________________________
4–6 Blastware Operator Manual
To ensure that monitor log entries and Events display in sequence, enable the Sort by date option
explained in the previous section.
To enable this option, click on the checkbox to display a checkmark.
b. Units and Channel
(1) Show Mic in dB
The microphone units are either Metric, Pa (Pascal), or Imperial, pounds per square inch (psi).
To choose dB units, click on the Show Mic in dB checkbox to display a checkmark. To disable
dB units, click on the checkbox again to remove the checkmark.
(2) Show Mic in Linear Units
The microphone units are Metric, Pa (Pascal), or Imperial, pounds per square inch (psi).
To choose Linear units, click on the Show Mic in Linear Units checkbox to display a checkmark.
To disable Linear units, click on the checkbox again to remove the checkmark.
(3) Measurement Units
You can print an Events Event Summary Report using either Imperial or Metric measurement
units. To select the measurement unit for the Event Report, click on the Measurement Units
drop–down menu and click on either Imperial or Metric.
(4) Time Display Format
You have the choice between 24 and 12 hour time displays.
To choose the 24 hour time display, click on the 24 Hour button. To use the 12 hour display, click
on the 12 Hour (AM/PM) button.
(5) Select channels to show on compliance Event report`
With this command, you can choose which channels to display on an Event report. You must
choose at least one channel per report.
NOTE: Some analysis results cannot be calculated if the required channel is not chosen. For
example, a Peak Vector Sum calculation cannot occur if either channel 1, 2, or 3 was not chosen to
appear within the Event report. To show all channels, click Show All.