System information

__________________________________________________
Blastware Compliance Module
Blastware Operator Manual 4–7
NOTE: Ensure that you select only the channels associated with the type of unit that you are
obtaining the Events from, Series II and III, Series IV or Micromate.
c. Compliance Scaling
(1) Waveform Compliance Event Reports Scaling
You can either use the default selection for viewing the amplitude of the Recorded Peak of the
Geophone, Linear Mic, or “A” Weight Mic channel, or define the Maximum Amplitude by
clicking on the radio button underneath the heading Entered Maximum Amplitude, and enter a
value for each channel.
(2) Time Scale
View the complete Time Scale of the Event by selecting Entire Event, or view a portion of the
Event by entering a specific Time Scale in seconds. The default Time Scale is -0.25 second to 1
second – this negative number accounts for the pre-trigger set for compliance monitoring. If
Entire Event has not been selected, then it is noted on the Event Report.