System information

Blastware Compliance Module
___________________________________________________
4–14 Blastware Operator Manual
(8) Test Communications
This checks the communications between the computer and the monitor. After you have
completed all connections and setups, press the Test button. The response “Communications OK”
indicates proper communication between the computer and the monitor.
(9) Dial
For modem communications only. See Chapter 7.
(10) Hang Up
For modem communications only. See Chapter 7.
(11) Initialize PC Modem
For modem communications only. See Chapter 7.
(12) Initialize Remote Modem
For modem communications only. See Chapter 7.
(13) Debug
For modem communications only. See Chapter 7.
b. Series IV Communication Setup
This option is available with the Ethernet Communication Cable, Minimate Pro to PC
(Part No. 720A4101). A router or Ethernet card hardware is supplied by the customer.
Ethernet communication feature includes downloading recorded events and uploading
setup files to the unit at a much faster rate than serial or USB. And, with the optional
Blastware Advanced Module, the ability to view Histogram data in real-time is
available.
Below is a table describing the common terminology used for this communication
protocol, followed by brief descriptions for each command within the Series IV