System information

__________________________________________________
Blastware Compliance Module
Blastware Operator Manual 4–21
35. Under the General tab, select “Use the following IP address:” and input an IP Address.
The first three sets of numbers (in this example, 192.168.1) must match the Static IP
Address that was provided by the Internet Service Provider. The last number must vary,
but cannot be “255” as that is reserved for another protocol. If supplied, or a WAN, enter
the Static IP Mask number into the Subnet Mask value field, otherwise use
255.255.255.0. Below is an example of a Static IP Address and a LAN Subnet Mask:
36. Start Blastware. Within Blastware, select the Unit > Communications menu. The
Communications Setup dialog appears.
37. Select the Series IV Ethernet communications option.
38. Select the Static IP Address option. The value field to the right will become available
for editing. Enter the Static IP Address supplied by the Internet Service Provider – it
must match the number entered into the Static IP Address field on the unit.