System information

Blastware Compliance Module
___________________________________________________
4–22 Blastware Operator Manual
NOTE: Select UDP/IP if you are communicating with a modem that supports
the UDP Protocol, otherwise select the TCP/IP Protocol. The TCP/IP
Protocol is recommended.
39. Attach the unit to the router, or directly to the PC Ethernet port, depending on the
Ethernet communications cable and associated hardware that was purchased. Wait for
approximately 1 minute for Windows to establish communications.
Select the Test button within Communications Setup to ensure that the
communications link has been established. If you receive a message, Timeout on
waiting for Response from the Unit!, ensure that the Static IP Address and
Static IP Mask values correlate with what the Internet Service Provider supplied
and what was input on the unit and within Blastware. With a successful
communication link, you will receive the message below:
Click on OK and then Exit to return to the Communication Setup dialog. Press
Close to exit to the Blastware Event Manager.
40. After successfully completing a communications link, click on Close to exit the
Communications Setup menu.
41. Within the Blastware Event Manager, select the Series IV Unit icon to display the unit
(or units if using a router, as in the example below) that is available for communication:
4.2.2 Compliance Setup – Series II, Series III and Micromate
NOTE: The Series IV Compliance Setup is covered in the next section.
This section of the manual reviews the Compliance Setup for Series II, Series III and
Micromate units. To display the Compliance Setup preferences window select the Unit Type and