System information

__________________________________________________
Blastware Compliance Module
Blastware Operator Manual 4–35
(1) Unit Timer
The timer function sets the monitor to automatically turn on and start monitoring operations at a
preset time in the future. The timer can be set for a one time monitoring session or it can be set to
record at the same time every day. Using the timer extends the monitors battery life by turning on
and monitoring only the time periods when Events occur and not the time periods between Events.
Note: When using a monitor in the Timer Mode, the monitor stops recording even if Event
activity is present and exceeds the trigger levels. The monitor waits until after the present
Event is recorded. If recording in the Histogram Record Mode, the monitor stops recording
immediately and discards the last histogram interval if incomplete.
(2) Timer Mode
The timer can be set for a one time operation or repeated operations at the same time each day.
i Off
Choose this setting if you do not require the unit timer.
ii Monitor Once Only
Choose this setting if you want the monitor to turn on monitor for a set period of time, then
turn off. Open the Timer Mode drop-down menu and choose Monitor Once.
• Start Date
Enter the calendar date when you want the monitor to turn on.
• Start Time
Enter the time of day when you want the monitor to turn on and start monitoring.
• Stop Date
Enter the calendar date to turn the monitor off.
• Stop Time
Enter the time of day to turn the monitor off and stop monitoring.