System information

__________________________________________________
Blastware Compliance Module
Blastware Operator Manual 4–41
a. Recording Setup
To display the Series IV Recording Setup dialog box, open the Unit, Setup, Compliance Setup
to view the setup tab. If a unit is communicating with Blastware then the current setup
information will be displayed. If a unit is not attached, than the software will prompt to ensure
that you still want to view the Compliance Setup.
The Recording Setup dialog box programs the selected sensors, source and triggers level, as well
as the Record Mode and associated Record Mode settings. After you have entered your settings in
each dialog box, choose Send to Unit to transfer your settings to the monitor, or under the Setup
Files tab, you can save each setup file to your local hard drive for later use or inclusion in
recording sessions using the Monitor Scheduler, located under the Special Setups tab. Refer to
the Monitor Scheduler section for more information on this feature.
Note: VDV Record Mode is optional and available with the purchase of the Blastware
Advanced Module.
(1) Vibration Channels
i Vibration Channels 1, 2, 3 Enable (Minimate Pro4 and Minimate Pro6)
To enable Channels 1, 2, 3, dedicated to vibration monitoring, select the check box next to
Vibration Channels 1, 2, 3 Enable. Determine which geophone that you are going to use for
monitoring, ISEE Geo or DIN Geo, attach it to the unit and select the appropriate box.
To select the Geophone channels as a Trigger Source, place a checkmark in the box. The Trigger
Level box value is enabled for entering values. The trigger level sets a threshold that must be
exceeded by an Events activity before the monitor begins recording. Use your judgment when
setting a trigger level. You must set the level high enough so the unit does not trigger on unwanted
Events such as nearby vehicle traffic. At the same time, you have to set the trigger level low
enough so that an Events activity exceeds the trigger level and starts the unit recording.