System information

__________________________________________________
Blastware Compliance Module
Blastware Operator Manual 4–57
b. The calendar will automatically populate with the previously saved
settings. Transfer the Monitor Scheduler settings to the unit. At this time,
you will be prompted with the following dialog:
c. Select Yes if you want the unit to
start using the Monitor Scheduler settings the next time a recording
session is initiated, either via Blastware or as a manual key press on the
unit. Select No if you don’t want Monitor Scheduler to be enabled.
(2) Sensor Check
This setting chooses when to automatically run Sensor Check to test your monitor and its sensors.
You can choose to run Sensor Check after recording each Event or only once before a monitoring
session starts. You can also choose to disable Sensor Check. If you choose After Each Event,
Sensor Check runs after recording each Event. Results are saved with each Event and appear on
the monitor display. If you choose Before Monitoring, Sensor Check runs once before
monitoring starts, immediately after you enter the monitor mode. The results of this single Sensor
Check appear with each Event recorded during the monitoring session. This setting provides a
zero recycle time and ensures you cannot miss an Event when using the continuous record mode
(the Automatically Print Event After Recording function in the Printer Setup dialog box must also
be turned off).
To select a Sensor Check position, click on the Sensor Check drop-down menu. Click on After
each Event or Before monitoring. Select Disabled if you do not wish to use Sensor Check.
(3) Measurement Units
The Blastmate III and Minimate Plus use either Metric or Imperial measurement units.
To choose the measurement units, position the mouse pointer on the Measurement Units drop–
down menu and click. Click on either Metric or Imperial.
(4) Show Mic units in dB
Select Show Mic Units in dB if you want to change from the default display units of Pa.
(5) Time Format
This sets the time format for the monitors clock. You can choose between the 24 hour and the 12
hour AM/PM time formats.
To choose a time format, click on either button.
(6) Set Unit Time with Setup
To synchronize the Unit clock with the personal computer clock, place a checkmark in the box
prior to selecting Sen
d to Unit. Disable Set Unit Time with Setup by clicking on the checkbox
to clear the checkmark.
(7) Command Buttons
To choose one of the following command buttons, click the mouse pointer on the button.
i Cancel
Exit the dialog box and return to the Blastware Main Menu.
ii Send To Unit
Transfer your settings to the monitor.