System information

__________________________________________________
Blastware Compliance Module
Blastware Operator Manual 4–59
(3) Button Commands
To choose one of the command buttons, click the mouse pointer on the button.
i Cancel
Exit the Printer Setup dialog box and return to the Blastware Main Menu.
ii Send To Unit
Transfer your settings to the monitor.
e. List Operator (Series IV and Micromate Only)
With communications successfully setup between the PC and unit, you can view and select which
Operator you want to appear on all current and subsequently recorded Events. You are also able
to Rename, Delete and Add operators. To display the List Operators dialog box, open the Unit,
Setup, and select List Operators:
NOTE: The Active Operator is shown at the top of the dialog. Operator names are limited
to 15 characters.
1. Highlight the Operator that you would like to appear on the reports by using the Select
button.
2. Click on the Select button to change the operator.
3. Click on OK to confirm the change, or Cancel to exit the menu without changing the
Operator.
4. Repeat the Steps 1 and 3 above to Rename, or Delete an Operator.
5. To Add an Operator, place your cursor in the top box and type in a new Operator
name. Click on Add and it will appear in the list below.
6. Click on OK to confirm the change, or Cancel to exit the menu without changing the
Operator.
f. List Setup Files (Series IV and Micromate Only)
With communications successfully setup between the PC and unit, you can view and select which
Setup File you want to use on all subsequently recorded Events. You are also able to Rename,
Delete and Select the Setup Files.
To display the List Setup Files dialog box, open the Unit, Setup, and select List Setup Files: