System information

__________________________________________________
Blastware Compliance Module
Blastware Operator Manual 4–61
6. Select each field and type the information that you would like displayed on the unit
Owner Info window.
7. Select the Send to Unit button to send the information to the attached unit.
8. Select the Cancel button to return to the Blastware Event Manager window.
4.2.4 Status
The Status command checks the monitor and displays the following information. To display the
Status dialog box, open the Unit Menu and choose Status. Press the Refresh button to update the
information. Press the Close button to return to the Main Menu. Below is an example of the Unit
Status for a Minimate Pro6:
4.2.5 Sensor Check
This command runs Sensor Check and checks the Blastmate III, Minimate Plus or Minimate
Pro Geophone and Microphone sensors. For Series III, if you have selected a 4.5 Hz Geophone in
the Channel Setup dialog box, the unit will perform a continuity test rather than the standard
Sensor Check test. To display the dialog box, open the Unit Menu and choose Sensor Check.
Test results of the last Sensor Check performed by the monitor appear in the box. If no results are
available, the word None appears in the Test Type column. Rows of dotted lines (---------) fill each
of the other columns. Below is an example of a Sensor Check on a geophone (Channels 1, 2, and
3, or Tran, Vert, Long) attached to a Minimate Plus.
a. Close
Choose this to return to the Main Menu.