Specifications

l FDC
Your system provide on board FDC and it supports two
floppy disk drive to your system. If you use another FDC
in your system using external Card, you should disable
this option.
l HDC
The system has on bord IDE type HDC. If you’d like to
another type of HDC (for example, SCSI, or ESDI etc.),
disable this option and install your HDC Card to the
expansion slot on the backplane board.
Leaving the Setup Program
When you have completed the changes, press the < ESC >
key. The SETUP program will display the message:
Write data into CMOS and exit (Y/N)?
If you have made any mistakes, press N for No, then move the
cursor back up to the beginning and verify each parameter,
making any corrections necessary. When you are satisfied with
the option settings, press the <ESC> key, then press Y to
write the new settings into the configuration RAM. Your
computer will run through the self test diagnostics again and
try to read a diskette in the first floppy disk drive.
As mentioned above, you may see an error message if you don’t
have a system diskette inserted into the floppy disk drive.
2-10 The CMOS Setup Program