Start Here Card

ManualsBrandsEpson ManualsPrint & ScanCX5200

1 Insert the paper support into its two grooves.

2 Set the feeder guard into its two slots in front of the

paper support.

3 Open the output tray and pull out the extension.

EPSON Stylus

CX5200

Start Here

1 Press and hold the On button for 2 seconds. The green light flashes

and the scanner carriage and print head move.

2 Lift up the entire scanner unit.

3 Shake the package of ink cartridges four or five times.

Then remove the cartridges from the package.

Caution: You must install all cartridges and leave them installed

for all types of printing. To avoid damaging the Stylus CX, never

move the print head by hand.

4 Lower each cartridge into

its holder as shown.

5 Press down on each cartridge

until it is firmly seated.

Install Ink Cartridges

1 Flip the feeder guard forward.

2 Slide out the edge guide.

3 Place a stack of paper against the right side of the feeder,

but don’t push it in. Slide the edge guide against the paper.

4 Flip the feeder guard back over the stack of paper.

1 Open the scanner lid, as shown.

Remove any packing materials

under the lid.

2 Slide the transportation lock

back to the unlock position.

Caution: Make sure you

unlock the scanner, or it

won’t work.

3 Close the scanner lid.

1 Make sure you have all the parts shown here. If any parts are missing,

contact EPSON as described on the back of this sheet.

2 Remove any tape and packing materials, as shown.

Note: Make sure you remove all the tape. There may be packing

materials or tape in different locations. Do not remove the sticker

covering the USB port yet.

3 Lift up the entire scanner unit.

4 Peel off the tape from the ink cartridge holder and from the top of the

printer. Make sure you don’t leave any tape inside.

5 After you have removed all the packing materials, lower the

scanner unit.

Unpack

Unlock

Turn over

1 Plug the Stylus CX into a grounded electrical outlet.

Do not connect the USB cable yet.

Plug In

Load Paper

6 Lower the scanner unit.

The Stylus CX begins charging the ink delivery system.

Charging takes about 2 minutes. The green light flashes and the

Stylus CX makes various sounds. Don’t turn it off while the green

light is flashing or you’ll waste ink.

continued

Attach the Parts

Paper support USB cable

Software

CD-ROM

Booklet

EPSON Stylus CX5200

Ink cartridges Feeder guard

Press the

On button

continue

Don’t remove

this sticker yet

Don’t touch the green part

4040293-00 CPD-15142R1

Summary of content (8 pages)

PAGE 1
Start Here EPSON Stylus CX5200 4 Plug In ® 1 Unpack 4040293-00 CPD-15142R1 1 2 Unlock 1 Make sure you have all the parts shown here. If any parts are missing, contact EPSON as described on the back of this sheet. 1 continued 6 Lower the scanner unit. Plug the Stylus CX into a grounded electrical outlet. Do not connect the USB cable yet. Open the scanner lid, as shown. Remove any packing materials under the lid. The Stylus CX begins charging the ink delivery system.
PAGE 2
Start Here EPSON Stylus CX5200 4 Plug In ® 1 Unpack 4040293-00 CPD-15142R1 1 2 Unlock 1 Make sure you have all the parts shown here. If any parts are missing, contact EPSON as described on the back of this sheet. 1 continued 6 Lower the scanner unit. Plug the Stylus CX into a grounded electrical outlet. Do not connect the USB cable yet. Open the scanner lid, as shown. Remove any packing materials under the lid. The Stylus CX begins charging the ink delivery system.
PAGE 3
Start Here EPSON Stylus CX5200 4 Plug In ® 1 Unpack 4040293-00 CPD-15142R1 1 2 Unlock 1 Make sure you have all the parts shown here. If any parts are missing, contact EPSON as described on the back of this sheet. 1 continued 6 Lower the scanner unit. Plug the Stylus CX into a grounded electrical outlet. Do not connect the USB cable yet. Open the scanner lid, as shown. Remove any packing materials under the lid. The Stylus CX begins charging the ink delivery system.
PAGE 4
Start Here EPSON Stylus CX5200 4 Plug In ® 1 Unpack 4040293-00 CPD-15142R1 1 2 Unlock 1 Make sure you have all the parts shown here. If any parts are missing, contact EPSON as described on the back of this sheet. 1 continued 6 Lower the scanner unit. Plug the Stylus CX into a grounded electrical outlet. Do not connect the USB cable yet. Open the scanner lid, as shown. Remove any packing materials under the lid. The Stylus CX begins charging the ink delivery system.
PAGE 5
7 Install Software continued For Macintosh® installation instructions, see the booklet that came with your Stylus CX. Follow the steps below to install software for Windows.® 1 9 When you see the final screen, make sure the Stylus CX is still on and paper is loaded. Click Print Test Page. Any Questions? Copying Photographs Select settings Make more than one copy On-screen EPSON Information Center Make sure the Stylus CX is not connected to your computer, then turn on your computer.
PAGE 6
7 Install Software continued For Macintosh® installation instructions, see the booklet that came with your Stylus CX. Follow the steps below to install software for Windows.® 1 9 When you see the final screen, make sure the Stylus CX is still on and paper is loaded. Click Print Test Page. Any Questions? Copying Photographs Select settings Make more than one copy On-screen EPSON Information Center Make sure the Stylus CX is not connected to your computer, then turn on your computer.
PAGE 7
Install Software continued For Macintosh® installation instructions, see the booklet that came with your Stylus CX. Follow the steps below to install software for Windows.® 1 9 When you see the final screen, make sure the Stylus CX is still on and paper is loaded. Click Print Test Page. Any Questions? Copying Photographs Select settings Make more than one copy On-screen EPSON Information Center Make sure the Stylus CX is not connected to your computer, then turn on your computer.
PAGE 8
7 Install Software continued For Macintosh® installation instructions, see the booklet that came with your Stylus CX. Follow the steps below to install software for Windows.® 1 9 When you see the final screen, make sure the Stylus CX is still on and paper is loaded. Click Print Test Page. Any Questions? Copying Photographs Select settings Make more than one copy On-screen EPSON Information Center Make sure the Stylus CX is not connected to your computer, then turn on your computer.