User's Guide

Captured still images are stored in the internal memory, an SD card, or a
USB drive. If there is more than one save destination, the priority is as
follows: USB drive > SD card > the internal memory. If the save destination
only has a small capacity remaining, the image is saved in the next
destination.
a
Images are saved in JPEG format.
a
Insert an SD card face-up or connect a USB drive, if needed.
a
When you store images on a USB drive, make sure you set
Function > USB Mode to Application.
b
Display the live camera image you want to save. Adjust any
settings, as needed.
c
Press the [ ] button to capture the image. Press and release
when you use the remote control, press and hold when you use
the control panel.
You see the displayed in the upper right of the screen, and the
image is saved.
a
Using the control panel, if you press and release the button
without holding it, the image is frozen on the screen instead of
being saved in memory.
d
Repeat steps 2 and 3 for any additional images you want to save.
a
• If all of the save destinations only have a small capacity
remaining, "The memory is full." is displayed and the image is
not saved.
• Do not disconnect the power cable from the document
camera or remove an SD card or USB drive from the
document camera while exporting data. Otherwise, the data
may not be saved properly.
Saving Images
39